Motion for the EC12 Class

Motion by Rick West, 10176

The motion is to amend Section 2.5 from:

 2.5 Maximum keel width after joining of hull halves and placement of lead shall not exceed 2.1"(53 mm).

To read:

2.5 Authorized manufacturers shall verify that the maximum keel width of hulls produced shall not exceed 2.1 inches (53.340 mm) with or without the placement of lead.

2.5.1 The maximum keel width of hulls with placement of lead subsequent to verification by the authorized manufacturer shall not exceed 2.145 inches (54.483)

Explanation for the change

Should this be the will of class by this polling, the motion will be submitted to the AMYA Executive Secretary for publication in Model Yachting and class vote by ballot in 2006.

The polling will end September 11, 2005

Poll: Vote for one

·        I approve of this motion for rule change.

·        I disapprove of this motion for rule change

·        I don’t care.